03CTDCO

Having difficulty removing the hub bearing assy to replace
my ball joints. Seams to be froze in there. Any tips or tricks
to get these out without damage ?
Thanks

benroberts3605

this has worked for me everytime, i loosen all the bolts start them back in and then using an impact socket and short extension. place the socket assembly back on the bolt, i place a prybar against the extension, find a solid spot too wedge it against start the truck and use the power steering to push it out, ive done it several times on 2nd gen trucks

garr_trenching@

I had good luck with the way benrobert3605 described other than I used a buddy to turn the streering wheel while I carefully held extension, Little pressure on front then back then popped right off. Good luck.