Head Gasket Problems
01-13-2004, 11:06 AM
#1
Registered User
Thread Starter
Join Date: Jan 2004
Location: Nashville,IN
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Head Gasket Problems
Have questions reqarding replacing head gasket on a '97 2500 with a 5.9. Two thicknesses of gasket are offered? Which one? Also does anyone out there have the torque specs for this job?
01-13-2004, 04:29 PM
#2
Registered User
Join Date: Nov 2002
Location: Salem,In.
Posts: 745
Likes: 0
Received 0 Likes
on
0 Posts
Get the thicker gasket it lowers the compresion a little but not enough to tell. Tourqe # are Step 1 all bolts to 66 ft lbs, step 2 long bolts 89 ft lbs, step 3 all bolts turn an additional 90- degrees, per Haynes Manual.
01-21-2004, 06:14 AM
#5
Registered User
Join Date: Jan 2002
Location: Milner, Georgia
Posts: 507
Likes: 0
Received 0 Likes
on
0 Posts
Always replace the head bolts. Also when you torque the head start in the center and work out. Front to back.Center front, center back.
There is a procedure to use.
..PT..
There is a procedure to use.
..PT..
Thread
Thread Starter
Forum
Replies
Last Post
ted_pulliam
24 Valve Engine and Drivetrain
8
07-16-2009 11:33 AM
wildchild97
Performance and Accessories 2nd gen only
7
09-25-2007 02:44 PM
Conn
12 Valve Engine and Drivetrain
6
12-29-2006 06:30 AM