maddog1927

Looking for a little better set up for the sand dunes than my stock 3rd gens, and michellins aired down to 10 PSI. Although this combo has taken me some trully amazing places, it is just not enough to pull the 5er through deep sand, is time to upgrade. The H1 2 piecers with internal beadlock seam to be a "cheap" fix. Wheels are inexpesive as well as 37" military surplus tires

So has anyone tried this?

The H1's are 16.5". I have read many a post about 16.5 alloys not fitting, but wondering if a steel would.

Also does anyone have experiance with the h1 2 piecers w/ internal bead locks. How do they perform.

Any pics of a 3rd gen with them?

pullin hard

not a chance, i have those rims modified to fit my 1 ton axles in a rock crawler, and they will not fit the brakes on the newer dodges.

maddog1927

yea, bolted one on today. it fit, but would not turn due to inerfearance with the caliper.

mikmaze

maddog, how close was the fit? would a spacer ring behind the rim help ? say a half inch ?

maddog1927

maddog, how close was the fit? would a spacer ring behind the rim help ? say a half inch ?

They were . A spacer might just do it. I should have bought one to tinker with.