SOhappy

Will hit 100k next month and the grab handle finally broke (wife did it, ...SHHHHHH don't tell or I'll get in ALL KINDS OF TROUBLE!!! )

Anyone tried these bushings?

http://www.imcoproductsinc.com/page/dodgeramaccesories

Are they just glued on to the post?
Any other suggestions?

Peterbilt

I used a DIY repair kit some posted using an electrical copper end cap. I worked on the passengers side great. On the drivers side I bought a new pillar for about $28. I t looks improved from the older version and has worked great. Don't forget to torgue the screws. I think they are 55 inch-pounds.

Pete

bettamsw

I think genos garage has a repair kit

SOhappy

Thanks guys, looks like the Genos kit is the Imco product. Wonder why the kit includes eight bushings? For the rear too? Also wondering what adhesive they use...

mattk50

I used the copper cap method and worked very good and at less than 2 dollers can't beat it

SOhappy

I searched for that and couldn't find much on it. Do you bond that on as well? What adhesive works best?

mattk50

No just take the grab handle off and get a copper cap that will fit over the mount in the back ond drill a hole in it re mount and you are good to go

Prodart440

Would you happen to remember what size cap fit??