bcool

I can run it with a return or i can run it as a standard regulator. If i should run it with a return where should i tap in for a return line?

Thanks,
Brendan

Mike D

No return needed.

bcool

Yeah reading into it, i don't even think i have to use the **** regulator. Thanks!

babyjoe

If you run with the stock pump no need for a return and dont' need a regulator either way....

bcool

Well i was planning on bypassing the stock LP

bcool

Oh and will the stock lift pump Power wires be suitable to run the holley?

larabeejj

Yes I have the stock wires hooked up to mine just make sure you turn on the ignition to find out which wire is the power wire. It works better that way so when you turn the key on it turns on the pump for a second then shuts off after pressure is built up. If you hook it up somewhere else it will continually run while the key is in the on position before you start it.

babyjoe

Ya it will work fine, if you have the resources make duetz connector to plug right in...if you run the stock with it you have to run a relay.

Mike D

Did ya'll know that the ECM provides power to the lift pump? How many amps with the Holley Blue draw over the stock lift pump?

I would advice using a relay.

bcool

Woo! 20PSI with a drop to 15 psi. Couldn't ask for much more. Thanks to everyone