Goerend transmission install pictures
#1
Registered User
Thread Starter
Join Date: Oct 2003
Location: Albuquerque, NM
Posts: 1,292
Likes: 0
Received 0 Likes
on
0 Posts
Goerend transmission install pictures
I got my new trans today and started tearing into it, I will try to post lots of good pics. im planning on opening up the transfer case too.
heres the new trans. its a full Goerend piece with billet flex plate, 1 piece Sonnex billet input shaft, and all the other goodies to include a double deep pan. I didn't get a billet output or intermediate shaft though.
heres the new trans. its a full Goerend piece with billet flex plate, 1 piece Sonnex billet input shaft, and all the other goodies to include a double deep pan. I didn't get a billet output or intermediate shaft though.
#2
Registered User
Thread Starter
Join Date: Oct 2003
Location: Albuquerque, NM
Posts: 1,292
Likes: 0
Received 0 Likes
on
0 Posts
time to come out with the old slush box
If I remember correctly, the fluid was RED when I put it in there haha.
I don't remember putting metal shavings and chunks in the fluid either.
If I remember correctly, the fluid was RED when I put it in there haha.
I don't remember putting metal shavings and chunks in the fluid either.
#3
Hey there,
I also have a 95 and am looking to upgrade my transimission so that I can add a little power without problems. Do you mind me asking how much you paid for the whole setup?
DK
I also have a 95 and am looking to upgrade my transimission so that I can add a little power without problems. Do you mind me asking how much you paid for the whole setup?
DK
#5
Registered User
Join Date: Mar 2006
Location: Eastern Shore of Maryland
Posts: 1,140
Likes: 0
Received 0 Likes
on
0 Posts
Thats good stuff, we have 2 on the way to the shop right now, What you going to do inside the transfer Case? Their pretty simple if you've never been in one.
Brett
Brett
Trending Topics
#9
Registered User
Thread Starter
Join Date: Oct 2003
Location: Albuquerque, NM
Posts: 1,292
Likes: 0
Received 0 Likes
on
0 Posts
the transfer case is just getting new seals and a T-case saver
#12
Registered User
Thread Starter
Join Date: Oct 2003
Location: Albuquerque, NM
Posts: 1,292
Likes: 0
Received 0 Likes
on
0 Posts
someone tell me what that piece is that is above and to the left of the crank? the thing with the gasket stuff all over it. there is a hole in it and it appeared to be leaking some oil when I pulled the adapter plate off. heres a pic with the oil seal plate off.
heres the rear main seal
heres the new seal installed, and the trans adapter plate reinstalled and torqued to 57 foot pounds
New Billet flexplate torqued to 105 foot pounds
heres the rear main seal
heres the new seal installed, and the trans adapter plate reinstalled and torqued to 57 foot pounds
New Billet flexplate torqued to 105 foot pounds
#15
Registered User
The part with the arrow pointing towards it is the rear end of the camshaft housing. There is a kind of freeze plug in it (but there is no water behind it)
HTH
AlpineRAM
HTH
AlpineRAM