gauge install
#1
Registered User
Thread Starter
Join Date: Aug 2004
Location: Sacramento
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
gauge install
Im trying to install a trans temp gauge, where the best places to tap into the wires for the Sender, Ignition (dimmer switch) and ground wires.
I overheated the trans in Arizona last week . So I guess I need a gauge. Nothing was hurt but my pocket book for a trans service.
2004 CTD early 5.9 SLT QB 4x4
Air aid
XZT
Thanks, Marc
I overheated the trans in Arizona last week . So I guess I need a gauge. Nothing was hurt but my pocket book for a trans service.
2004 CTD early 5.9 SLT QB 4x4
Air aid
XZT
Thanks, Marc
#2
Registered User
Join Date: Feb 2008
Location: Elkridge, MD
Posts: 732
Likes: 0
Received 0 Likes
on
0 Posts
if you go to dieselmanor.com i believe that have instructions online. The sender can just be tapped into i think a pink/yellow wire in the main harness under the dash and the dimmer i don't remember, but i know for sure dieselmanor.com has the intructions on there. Or you can get some add-a-circuits and just connect them to the fuse panel, 12v switched and dimmer fuse. and the ground wires should be common sense, just use the ground bolt behind the dash that i think 4 other grounds are going to
#3
Registered User
Join Date: Feb 2008
Location: Elkridge, MD
Posts: 732
Likes: 0
Received 0 Likes
on
0 Posts
#4
Registered User
Im trying to install a trans temp gauge, where the best places to tap into the wires for the Sender, Ignition (dimmer switch) and ground wires.
I overheated the trans in Arizona last week . So I guess I need a gauge. Nothing was hurt but my pocket book for a trans service.
2004 CTD early 5.9 SLT QB 4x4
Air aid
XZT
Thanks, Marc
I overheated the trans in Arizona last week . So I guess I need a gauge. Nothing was hurt but my pocket book for a trans service.
2004 CTD early 5.9 SLT QB 4x4
Air aid
XZT
Thanks, Marc
hello. i just installed my gauges last week and used the instructions provided by DeiselManor. everything went as planned. the only thing i wasn't clear about and received help from the fine peeps here was "where" to tap into to gain control on dimming the lights for the gauges
Thread
Thread Starter
Forum
Replies
Last Post
spooled142
Performance and Accessories 2nd gen only
8
03-19-2009 09:10 AM
ado2b1
Performance and Accessories 2nd gen only
5
07-06-2007 10:27 PM
AndyMan
Other
3
05-11-2007 07:50 AM
QWKRTNU
3rd Gen High Performance and Accessories (5.9L Only)
1
09-26-2006 10:22 PM