Santaclaus

I have an acquaintance that works with fiberglass. I showed him my gauge cluster, it sits on top & to the right side of my instrument cluster. It was made to fit the curves of the dash. It holds 3, standards gages, the wires and tubes go down the side. My question is there any market for them? He thinks it wouldn’t be too had to copy it and possibly expand it to 4 or 5. Any other thoughts?

C Pierce

Tell him to make a prototype and send it to GENO'S he might be able to sell through him since GENO'S is already established and has a site

cowboydodge

do you have any pictures?

edwinsmith

Personally I prefer them on top of the dash. If I could find one like that I would buy it in a heartbeat. I have the cup mounts now which look OK but a molded job would look so much nicer. If you could make them with a Tach + 2 3 or 4 gauges you could sell them I bet.

Edwin

C Pierce

DEN made one from aluminum that's awsome. Also look over on TDR ther's a thread about using modified 2nd gen dash mount gen pod it looks good to.ahttp://dens-site.net/Dodge_CTD/Dash%20Pod/Dscn0090-small.jpg

C Pierce

sorry I cannot figure out how to make a link just do a search on DEN's posts and it will come up

rbrettctd

Thats neat looking, but sure not for anyone short.