Front end rub/grind
#1
Registered User
Thread Starter
Join Date: Jan 2002
Location: Naugatuck, CT
Posts: 445
Likes: 0
Received 0 Likes
on
0 Posts
Front end rub/grind
Hey guys:
I have a grinding/rattle that I can't figure out where it's coming from. When stopped and applying pressure to the steering wheel (toward the left), I hear a pretty loud rattle. Also, if I turn a hard left at speed, I'll hear a grinding sound from the front right. I've replaced the U-joints and hubs. Brakes look good, no marks and clears everything ok. The dust shields a clear and I can't see any marks on any rotating parts in the front. Doesn't matter if the front end is locked or not (4X4). Motor mounts look good and I don't see anything touching the frame, etc... Are there any bearings on the right side of the axle other than the hub? I think I have 2 different problems with the first being the PS pump and the second being a rub or bearing somewhere. Any help would be appreciated.
Truck: 96 4X4 2500
I have a grinding/rattle that I can't figure out where it's coming from. When stopped and applying pressure to the steering wheel (toward the left), I hear a pretty loud rattle. Also, if I turn a hard left at speed, I'll hear a grinding sound from the front right. I've replaced the U-joints and hubs. Brakes look good, no marks and clears everything ok. The dust shields a clear and I can't see any marks on any rotating parts in the front. Doesn't matter if the front end is locked or not (4X4). Motor mounts look good and I don't see anything touching the frame, etc... Are there any bearings on the right side of the axle other than the hub? I think I have 2 different problems with the first being the PS pump and the second being a rub or bearing somewhere. Any help would be appreciated.
Truck: 96 4X4 2500
#4
Registered User
Thread Starter
Join Date: Jan 2002
Location: Naugatuck, CT
Posts: 445
Likes: 0
Received 0 Likes
on
0 Posts
Exhaust is clear, motor/tranny mounts look good - nothing appears to be hitting. The sound is very pronounced after going over a speed bump when the front end compresses and rebounds. Brake calipers are sliding freely, no marks on the inside of the rims or the axle shaft at the tube or knuckle. I'm stumped...
Thread
Thread Starter
Forum
Replies
Last Post
Bmyers2500
3rd Gen Engine and Drivetrain -> 2003-2007
4
09-30-2007 03:41 AM
BlueDually
3rd Gen High Performance and Accessories (5.9L Only)
1
05-09-2006 06:40 PM
Gordonville
3rd Gen High Performance and Accessories (5.9L Only)
4
04-18-2005 09:45 AM