91rangerturbo

My Dana 60 is leaking around the what looks like the 4wd actuator (closer to the passenger side of the truck) where is bolt's to the axle itself. Is there a gasket for this? I looked online at some local parts houses and didn't turn anything up. It just started leaking after the truck sit for about 2 months.

Or should i just use some black RTV and roll on? And is there anything i need to be careful with when removing the actuator itself to repair this?

91rangerturbo

Anyone care to chime in?

Flatbed24v

I would also like to know this cause mine does the same thing

91rangerturbo

I couldn't find a gasket for it. I am sure the dealer probably has one for it. But i would think draining the front end and cleaning it up really well. Then some black RTV would seal it up just fine. I still haven't got around to doing it yet. I was waiting to see if someone had fixed this before.

sheriffav8r

The gasket comes with the CAD replacement part. It also has all the retainer rings for the CAD itself. I think the whole thing is about $100 and well worth it....

http://www.1aauto.com/1A/4WDrive/Dod...ze/1AFWA00007/

nickg

No need to drain the diff to remove the CAD, there's not enough oil in the tube to drain out and if there was you'd only loose a couple oz,

91rangerturbo

Well my CAD works just fine still. I guess i can just use RTV and pull it off and re-install. I don't see replacing something that there is nothing the matter with it. Just a leaking gasket.

REF>Lancer

That's what I'd do,the black RVT is good stuff.