Engine Block Heater Not Working
#1
Registered User
Thread Starter
Join Date: Nov 2003
Location: Kenton, OH
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
Engine Block Heater Not Working
I went out this morning to start my truck, which was plugged in and I noticed that my wait light stayed on much longer than normal. So I checked under the hood and the valve cover was cold as ice. My question is this.... Does the power cord go straight to the heater? Or is there a fuse somewhere? If not the heater must have bit the dust. If so anything special that I need to know to change it? And where is the cheapest place to buy one? I have owned the truck since new so I know it is the original heater. Thanks
2002 2500 4X4 Q/C S/B Atlantic Blue
2002 2500 4X4 Q/C S/B Atlantic Blue
#2
Registered User
Cord goes direct to the heater no fuse. Most likely the cord is bad at the plug. Go to the hardware store and buy a HD universal replacement end. You can cut the end off and ohm between the two wires. If there is no resistance the reat of the cord and element should be ok.
Thread
Thread Starter
Forum
Replies
Last Post