T-REX

Will I need gauges if I run the Edge EZ, and will I burn my clutch out.

Hoss

In my opinion, no, and probably not. I ran the EZ for around 30,000 miles without gauges and without any other problems.

973604x4

EZ level 3....0-80mph on a stock turbo i was at 1500* on my EGT gauge.

it won't burn your clutch though

BigDave12768

I just romped my truck down the highway on Extreme 100hp and the EGT's never went above 1050. But I ws empty and trying to configure the thing

Patrolman808

I ran the EZ maxed out for about 9 months. Never had a problem with the clutch, just sheared the flywheel bolts off in the crank. Guess the stock clutch holds pretty good

Dodgezilla

BigDave, those temps are a little low. I could hit 1200 degrees when my truck was stock. My Quad on the middle setting is probably close to an EZ on level 3 and I can easily hit 1400+ degrees on a hard pull......

Bikinaz

I can easily hit 1350 degrees pulling my trailer on a grade on level 1. Uh, yeah I would get gauges.

Patrolman808

I wish I had put my EGT probe in the manifold to see the readings there. I couldn't tell much with it after the turbo.

2broke2smoke

the wifes '06 can hit 1350 emtpy at wot and thats with a gutted cat and mbrp cat back ...

the first mod anyone should do on an '06 should be a pyro...