How do I ID rear gears etc.
#1
How do I ID rear gears etc.
I'm looking at a used 2007, 6.7, 4x4, SLT Big Horn, auto. This thing is like NEW. not a scratch on it and only 16K miles. I want to be sure I know what I'm getting.
On the prior generation there was a sticker in the glove box that told you what equipment was installed - rear end gears etc.. How about on the 2007's? How can I tell what rear gears it has?
Thanks
Ken
On the prior generation there was a sticker in the glove box that told you what equipment was installed - rear end gears etc.. How about on the 2007's? How can I tell what rear gears it has?
Thanks
Ken
#4
Yeah they told me the gears were 4.10's but that was coming from a salesman. Don't usually trust them on technical questions. I looked for a sticker like on my '04.5 but not there. Oh well. I'll wait and see if anyone else has any input and if not just go by what the salesman says.
Thanks
Thanks
#5
Registered User
send an email to this address and request a build sheet, they will email it to you:
customerassistre@chrysler.com
customerassistre@chrysler.com
Trending Topics
#9
Registered User
Take it for a test drive. 6.7L with an automatic and stock tires, you should be about 1650rpm @ 65mph if the truck has 3.73 gears. If it is higher RPMs then that, it is 4.10 gears. Those were the only two gear ratio's offered in the 6.7L automatic in '07.
Thread
Thread Starter
Forum
Replies
Last Post
BigJohnston
3rd Gen High Performance and Accessories (5.9L Only)
20
07-14-2019 10:58 AM