DIY Torque Tube
#1
Registered User
Thread Starter
Join Date: Dec 2004
Location: Elgin, TX
Posts: 955
Likes: 0
Received 0 Likes
on
0 Posts
DIY Torque Tube
I was wondering how easy it would be to make something to the effect of a torque tube. It seems like you should be able to put like a 4in piece of PVC or something in place of the baffle tube (I'm not sure what the actual name is). I saw a part that replaces just the baffle tube in Geno's Garage, and that is all I need. I don't really need the actual Torque Tube, it's too expensive and I don't see the need. Any ideas? Thanks.
#3
here you go.....http://intakehoses.com/Merchant2/mer...gory_Code=SIT7
cheap!!! and easy..this is so you can use the factory elbows...
cheap!!! and easy..this is so you can use the factory elbows...
#6
Registered User
Join Date: Dec 2006
Location: Stoutsville, Mo
Posts: 308
Likes: 0
Received 0 Likes
on
0 Posts
any metal pipe is more prone to sweating than plastic. and if it does whats it gonna hurt??? i know water methanol injection is after the turbo but i dont think a little sweat will cause anything. my k&n is the same as pvc pretty much
Thread
Thread Starter
Forum
Replies
Last Post
subspd
3rd Gen High Performance and Accessories (5.9L Only)
3
08-27-2006 02:17 PM
PROSOUTH
3rd Gen High Performance and Accessories (5.9L Only)
22
03-18-2004 05:29 AM