Cylinder head re-torque
#1
Registered User
Thread Starter
Join Date: Nov 2005
Location: Rohnert Park CA
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Cylinder head re-torque
Is there any need to re-torque the head bolts?Stock engine,150K, Banks PP, hits about 25-30 psi.
Im hoping I dont have a blown head gasket,but Ive got a stubborn coolant leak near the front corner of the head.
I though it was the thermostat housing,but after removing and replacing the stat,gaskets and housing twice,Ive still got a dribble from the same general area.Its a pair of trickles that run down to the waterpump from behind the stat housing.I thought itd be the stat housing,but it still leaks.I cant 100%verify its coming from the head because once the stat housing is in place and I can run the truck,the head/block surface at the corner isnt visible.....
Im hoping I dont have a blown head gasket,but Ive got a stubborn coolant leak near the front corner of the head.
I though it was the thermostat housing,but after removing and replacing the stat,gaskets and housing twice,Ive still got a dribble from the same general area.Its a pair of trickles that run down to the waterpump from behind the stat housing.I thought itd be the stat housing,but it still leaks.I cant 100%verify its coming from the head because once the stat housing is in place and I can run the truck,the head/block surface at the corner isnt visible.....
#2
Registered User
Join Date: Jun 2002
Location: dfw texas
Posts: 1,771
Likes: 0
Received 0 Likes
on
0 Posts
sounds like your head gasket has let free close to where mine went a couple weeks ago. i tried retorqueing, but it was not going to save me anything. but i had to try.
Thread
Thread Starter
Forum
Replies
Last Post
cLAYH
3rd Gen Engine and Drivetrain -> 2003-2007
2
10-11-2008 11:07 PM
cgmorgan06
3rd Gen Engine and Drivetrain -> 2007 and up
3
11-15-2007 04:02 PM
Journier
General Diesel Discussion
11
11-22-2004 02:56 PM