goodeyesniper75

Today i should be getting my spare FCA and was wondering....what if i just did the FCA first then finished the other part another time? any adverse effects?

soulezoo

None whatsoever! I've been running like that now for a couple of weeks. How much did the FCA run ya?

goodeyesniper75

like $90 plus shipping...how do you feel about the mod? did you notice anything?

tesla440

I reworked my FCA only. No problems. The low end power is great. Boost come on alot earlier & quicker. I also noticed my boost sits at 7psi at 70mph where before it would be 3-5psi. I'm checking to see if this help my mpgs any. If not it'll be up for sale.

goodeyesniper75

sounds good...i just took my spare one apart and i will be cutting it up tonight hopefully.

soulezoo

There is really nothing I could measure (like comparing before/after on a dyno) to tell me anything definitive. For most regular driving I saw no difference at all. The only difference I saw was on WOT runs. More smoke, faster spool, higher spool and power seemed to stay on longer meaning I was probably draining the rails before. This is all in conjunction with the lift pump upgrade too.

soulezoo

BTW-- + shipping? You didn't get it from the dealier then? Where did you source it?

goodeyesniper75

i went on the cummins site and looked up parts dealers. just gave them my part # and it was here the next day.

goodeyesniper75

well i just cut my FCA took about 2 mins on each side. what did you guys use to de-bur?

soulezoo

on the inside I used finest burr tool for the dremel I could get. On outside I used polishing wheel and compound and cleaned thoroughly afterward.

82NDSNPR

fca????? need info please have no clue what that part is

goodeyesniper75

its where the fuel comes into the cp3...by enlarging it and one other thing its basically a DIY stage 1 mod.

omaharam

I wouldn't term that as such. My stage 1 cp3 is much more extensive than elarging the passages of the fca.

Also, I was told just doing the fca gains very minimal. You need to modify the rotor housing to allow it to move enough fuel through the now modded fca.

goodeyesniper75

yes.....your correct...

82NDSNPR

k good to know i am going with a stage 3 cp3 so this does not need to be done in my case thanks for the info