commander ?
#1
commander ?
I just installed the Quad commander. Now my XZT goes through the led code and then goes blanK. No boost pressure. I selected the module XZT from the menu. Is my problem the MAP connection. I connected where the XZT harness plugs into the MAP.
Any suggestion?
Thanks for your response, I will be back in a couple of hours.
Any suggestion?
Thanks for your response, I will be back in a couple of hours.
#2
Registered User
Join Date: Aug 2006
Location: Riverside Ca.
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
I know theres 2 wire's that you have to splice on, I was geting some strange readings too, and after I asked Quadzilla they told me to check them and make sure they were makeing good contact.
After checking the wires and re-crimping the splice's eveything is back to normal.
After checking the wires and re-crimping the splice's eveything is back to normal.
#4
I disconnected the XZT from the Commander and the XZT is working. I think the Commander is suppose to control the XZT but I could only find the module selection. I could not find a menu for controlling the XZT.
#5
Registered User
The earlier ZXT's required a modification from Quad to make them work with teh Commander. Get your serial number and call Quad to see what the status of yours is and if it requires the mods to be done.
#7
OK, first make sure that you have the XZT connected to the right port on the Commander wiring harness. On the Commander side it should be a 4 pin connector but, it only has 2 wires in it, they are black and white.
Then go into the menu and go to the module selection and choose a Quadzilla XZT.
The next thing you need to do is when you hook it up to the Commander see what Power Level it is in on the display. This is on the right hand side in the middle. If it is in 0 then the LED will turn off. As you push the up button the number will change and the LED should go green (L1) orange (L2) and then Red (L3) which is the 65hp setting.
Forgive me if you have gone through this I just want to cover the basis first. We will get you up and running ASAP!
Then go into the menu and go to the module selection and choose a Quadzilla XZT.
The next thing you need to do is when you hook it up to the Commander see what Power Level it is in on the display. This is on the right hand side in the middle. If it is in 0 then the LED will turn off. As you push the up button the number will change and the LED should go green (L1) orange (L2) and then Red (L3) which is the 65hp setting.
Forgive me if you have gone through this I just want to cover the basis first. We will get you up and running ASAP!
Trending Topics
#8
Thanks qzilla, All I had to do is push the up button. Everything works. I had read where the Commander defaults to 0 but could not figure out how to increase the level.
Now I am a happy camper, thanks again
Now I am a happy camper, thanks again
Thread
Thread Starter
Forum
Replies
Last Post
stock03
3rd Gen High Performance and Accessories (5.9L Only)
3
11-09-2006 11:27 PM
rossn2
3rd Gen High Performance and Accessories (5.9L Only)
2
02-23-2004 07:34 AM