Clearing codes on a 1995 12V
#1
Clearing codes on a 1995 12V
I have a 1995 12V and I am wondering how to clear codes from the computer. I am getting a code 12 - battery disconnected, and a code 24 - throttle position too high/low.
I checked the TPS voltage and it was way too low. I adjusted it to 0.8 volts at rest but still have the code 24. Do I need to disconnect the batteries or should the code clear itself? I know the code 12 will clear itself after 50 key on/off cycles. Maybe I still need to increase the TPS voltage. I read here that the recomended voltage is between 0.8 and 1.2 volts at rest so I thought I would start at the lowest setting and work my way up.
Thanks!
I checked the TPS voltage and it was way too low. I adjusted it to 0.8 volts at rest but still have the code 24. Do I need to disconnect the batteries or should the code clear itself? I know the code 12 will clear itself after 50 key on/off cycles. Maybe I still need to increase the TPS voltage. I read here that the recomended voltage is between 0.8 and 1.2 volts at rest so I thought I would start at the lowest setting and work my way up.
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
deere nut
3rd Gen High Performance and Accessories (5.9L Only)
2
12-22-2005 08:16 PM