Cam sensor?
#1
Cam sensor?
While driving the other day my tach started jumping all around and went to zero a couple times! It did this for a couple minutes and then cleared up and didnt do it again until today! I stoped **** the truck off and it quit doing it! I was wondering if my cam sensor is going out or if i have a bad connection some where?
#3
Well its throwing the cam sensor code! Psomething i cant really remember! The truck was p-pumped last year and we just put it back to a vp and its taking awhile to get everything straightened out!
#4
Also right now im running without the tst since i had to send it back to get repaired! Will not haveing a boost fooler cause it to do this! It only starts to do it when i gets around 25lbs of boost!
#6
Registered User
Join Date: Jun 2006
Location: Lake Charles,Louisiana
Posts: 1,367
Likes: 0
Received 0 Likes
on
0 Posts
all i know is it doesnt have one behind the starter.
#7
Registered User
The 01 has the cam sensor and not the crank.. I just had the pleasure dealing with the 1690 code and the 341 code. For me it turned out not so good. I replaced the cam sensor but no go. Still 1690 and 341. Swapped in a spare ecm for kicks and no more 341 but still the 1690. Put the old ecm back in and instant 341/1690. Put the spare back and 341 goes away. Dropped in a new pump and no more 1690. So my pump and my ecm went out. My wallet is now significantly lighter.
Trending Topics
#8
Was your vp acting up? I got a brand new scheid lighting vp! So i really dont think its the pump! But the truck hasnt done this in awhile so i kind of think its a wek cam sensor!
Thread
Thread Starter
Forum
Replies
Last Post
etn550
3rd Gen Engine and Drivetrain -> 2003-2007
4
04-01-2010 12:12 PM