What brand lift blocks do you have on 3rd gen?
03-29-2007, 08:59 AM
#1
Chapter President
Thread Starter
Join Date: Dec 2005
Location: Asheville, NC
Posts: 498
Likes: 0
Received 0 Likes
on
0 Posts
What brand lift blocks do you have on 3rd gen?
I just installed a 5 inch rough country x-series on my 2005. The lift blocks for the rear do not work correctly with the two centering pins in the leaf springs. Does anyone have lift blocks that are drilled for these two pins instead of the plastic locator that's in the place of a typical center pin?
03-29-2007, 09:05 AM
#2
Registered User
Join Date: Dec 2005
Location: DFW, TX
Posts: 2,627
Likes: 0
Received 0 Likes
on
0 Posts
My superlift blocks are open in the front/back center area, and has the pin/hole for the springs already cast in.
I will be swapping to springs though, as soon as I get the extra money.(Either add-a-leaves, or maybe lorenz/carli mini pack)
I will be swapping to springs though, as soon as I get the extra money.(Either add-a-leaves, or maybe lorenz/carli mini pack)
03-29-2007, 09:29 AM
#3
Chapter President
Thread Starter
Join Date: Dec 2005
Location: Asheville, NC
Posts: 498
Likes: 0
Received 0 Likes
on
0 Posts
Mine also has the pin/hole but the hole is too small for the factory plastic alignment pin and the pin is too small for the hole in the spring perch on the axle.
03-29-2007, 10:25 AM
#4
Registered User
Join Date: Aug 2006
Location: Adkins Texas
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
I couldnt find any in one inch, so I fabbed a set myself. My brother works for outback offroad and ordered several 2" block sets and none of them were correct.
Thread
Thread Starter
Forum
Replies
Last Post
PourinDiesel
Competition / Pulls / OffRoad
20
03-12-2008 02:50 AM
PourinDiesel
3rd Gen High Performance and Accessories (5.9L Only)
0
02-15-2008 10:06 AM
Katmandu
12 Valve Engine and Drivetrain
10
01-16-2006 08:30 AM