brake light & abs as well
#1
Registered User
Thread Starter
Join Date: Jan 2010
Location: Waterford, Ontario
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
brake light & abs as well
Mine is similar to the previous post with the following exception. I had a draw tite flip ball gooseneck hitch installed this week. The guy said he didn't think I had the clearance to put the ball in upside down. Should have listened. I measured almost 3 inches from the bottom of the bed to the top of the axle. Well bang bang it sheared the right rear brake line in half. I replaced that today as well as the wheel cylinder. After bleeding the brakes with the engine off I now have the ABS light on & the brake light on. What will reset that? Battery off? Everything is fine & the brakes are working fine again. Parking brake is not dragging.
#3
Registered User
Thread Starter
Join Date: Jan 2010
Location: Waterford, Ontario
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
No. I drove it for a day with it snapped in half with no lights on. They only came on after I replaced the wheel cylinder & bled the lines.
#4
Registered User
Thread Starter
Join Date: Jan 2010
Location: Waterford, Ontario
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
One other thing that was odd, when the line sheared in half the differential valve did work or I wouldn't had any brakes yet the brake light never came on. It only came on after the wheel cylinder was replaced & the whole line from the master cylinder to the wheel cylinder was bleed.
Thread
Thread Starter
Forum
Replies
Last Post
Joey-D
3rd Gen Engine and Drivetrain -> 2003-2007
4
12-12-2011 12:52 PM
mr T
2nd Gen. Dodge Ram - No Drivetrain
10
02-24-2007 06:42 AM