Brake Job question
10-29-2003, 03:06 PM
#1
Registered User
Thread Starter
Join Date: Jun 2002
Location: Lanesville, IN
Posts: 588
Likes: 0
Received 0 Likes
on
0 Posts
Brake Job question
Going to do my first brake job on the 99 this weekend, putting Bendix Fleet MetLock pads and shoes all the way around. 
My question is, is there any special tools needed to do a brake job on these trucks? I've done lots of brakes in past just not anything this big.
Will a need any big Torx drivers or anything like that or is it all done with standard tools?
Thanks
DB
My question is, is there any special tools needed to do a brake job on these trucks? I've done lots of brakes in past just not anything this big.
Will a need any big Torx drivers or anything like that or is it all done with standard tools?Thanks
DB
10-29-2003, 04:19 PM
#3
Registered User
Join Date: Feb 2003
Location: Shippensburg, Pa
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
Re:Brake Job question
I jusr did my fronts on the '99 again yesterday. had a slide pin on the passagners side that was hung up. It just takes standard tools nothing extra.
10-30-2003, 08:50 PM
#4
Registered User
Thread Starter
Join Date: Jun 2002
Location: Lanesville, IN
Posts: 588
Likes: 0
Received 0 Likes
on
0 Posts
Re:Brake Job question
Picked up the Bendix pads and shoes this evening before work and will tackle the job in the AM when I wake up.
Oh Yea, those rear shoes are hudge. ;D
Thanks for the help guys.
DB
Oh Yea, those rear shoes are hudge.
;DThanks for the help guys.
DB
Thread
Thread Starter
Forum
Replies
Last Post