BigLine Install Help
#1
Registered User
Thread Starter
Join Date: Apr 2009
Location: McKinney
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
BigLine Install Help
I'm installing a BigLine kit from the filter to the injection pump on my '01 right now and diselautopower isn't open to help me out.
1. Do I reinstall the washers around the adapters that go into the pump and filter housing?
2. I had a fuel pressure sender with a tapped banjo bolt mounted at the injection pump. Do I reuse the tapped banjo bolt?
1. Do I reinstall the washers around the adapters that go into the pump and filter housing?
2. I had a fuel pressure sender with a tapped banjo bolt mounted at the injection pump. Do I reuse the tapped banjo bolt?
#2
Registered User
Thread Starter
Join Date: Apr 2009
Location: McKinney
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
Nevermind got it. Make sure when installing a bigline from the filter to the pump, I would leave the hose around 13" because if you cut it any shorter you won't be able to get the power steering fluid cap out. You also will run the 1/2" hose right next to the block which I'm assuming will heat the fuel going into the injection pump quit a bit.
#3
Registered User
Since you cant or shouldn't use that tapped banjo anymore, you should have one of these. http://www.vulcanperformance.com/push-lock-p/poet8.htm
Thread
Thread Starter
Forum
Replies
Last Post
spooled142
Performance and Accessories 2nd gen only
8
03-19-2009 09:10 AM
AndyMan
Other
3
05-11-2007 07:50 AM
UnrulyNFS
3rd Gen High Performance and Accessories (5.9L Only)
14
10-17-2006 08:57 PM
QWKRTNU
3rd Gen High Performance and Accessories (5.9L Only)
1
09-26-2006 10:22 PM
Mark Thomas
3rd Gen Engine and Drivetrain -> 2003-2007
11
07-08-2004 08:01 PM