Another Oil Pressure Question?
#1
Registered User
Thread Starter
Another Oil Pressure Question?
My stock guage will read in the middle when its cold. When its hot it will read 2 lines from low. What do these lines mean 10psi per line? Or should I just plumb in a mechanical guage from the filter housing and be done with it? I'm worried about pressure getting too low . Thanks.
#3
Registered User
Thread Starter
You just screwed the guage right in? no tubing or nothing. Didn't run it in the cab? Do you see a difference in the guage on the filter to the one in the cab?
Sorry for all the ?
Sorry for all the ?
#4
Adminstrator-ess
#5
Registered User
Thread Starter
Thanks Wanna, I have new cheapo sunpro guages that I was going to use on my '86 gasser. At least now I have a use for them. Where is the water temp sender on the cummins? Might as well plumb that up too. Sorry, where is the best place to plumb the oil guage? From the stock sensor location or the filter housing?
#6
Adminstrator-ess
Factory temp sender is toward the back of the head on the driver's side, most guys put their aftermarket probe near the thermostat housing (big pipe plug there).
Put the oil pressure wherever you feel like.
Put the oil pressure wherever you feel like.
Thread
Thread Starter
Forum
Replies
Last Post
leeboy
24 Valve Engine and Drivetrain
3
03-26-2008 11:08 PM
GlennRMK
HELP!
7
05-24-2007 10:46 PM
Power Ram 250 C
1st Gen. Ram - All Topics
4
02-20-2007 11:08 AM
Jezzhuntin
General Diesel Discussion
17
08-25-2006 02:51 PM
CIN'S DODGE
24 Valve Engine and Drivetrain
16
12-05-2005 04:14 PM