Air Dog owners where to install FP fitting
#1
Registered User
Thread Starter
Join Date: Jun 2006
Location: NJ
Posts: 422
Likes: 0
Received 0 Likes
on
0 Posts
Air Dog owners where to install FP fitting
I was just wondering where you guys were installing the fitting for your fuel pressure. I talked to toby and he said to drill and tap the fitting going to the CP3. I am curious what you guys have done. I will be installing the AD 100.
Thanks.
Thanks.
#2
Registered User
Join Date: Oct 2006
Location: greensboro
Posts: 411
Likes: 0
Received 0 Likes
on
0 Posts
I have a vp truck but I put it in the line about a 1.5 ft back from where the line goes into the pump and used a tee also am using the newer auto meter electronic guage.
#3
#5
here you go....
http://www.vulcanperformance.com/ser...08JIC-X/Detail
http://www.vulcanperformance.com/ser...08JIC-X/Detail
Trending Topics
#8
Registered User
Thread Starter
Join Date: Jun 2006
Location: NJ
Posts: 422
Likes: 0
Received 0 Likes
on
0 Posts
Mark, thanks for the link and write up!! Nice job!!!
I think I am going to drill and tap the one that came with the kit. I know that if something does go wrong I have a place to a new one. 17 bucks is a lot for the fitting ($17 includes shipping)
I think I am going to drill and tap the one that came with the kit. I know that if something does go wrong I have a place to a new one. 17 bucks is a lot for the fitting ($17 includes shipping)
#9
I understand the shipping part..I ordered the vulcan drawstraw for my install and just ordered it all at once...plus when you drill the one out that AD sends you it makes you have an extra fitting that other wise you would not need with the Vulcan fitting.....either way works great..I just wanted less fittings
#11
Administrator ........ DTR's puttin fires out and workin on big trucks admin
Yes you would, just make sure you have it anchored squarly in a drill press. You can always do the standard install and replace the fitting later?
Tim
#12
http://www.vulcanperformance.com/ser...-08-JIC/Detail
if you use a piece like this then you also have to use an additional straight JIC push lock fitting....the one I used is a 90* and a push lock in one fitting...
like I said either way works just fine....
Thread
Thread Starter
Forum
Replies
Last Post
trailinone
3rd Gen High Performance and Accessories (5.9L Only)
16
06-19-2009 04:28 PM
kev94mx
3rd Generation Ram - Non Drivetrain - All Years
19
06-15-2007 07:33 PM