Adjusting wastegate on a 00'
#1
Registered User
Thread Starter
Join Date: Feb 2008
Location: Havre de Grace, MD.
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Adjusting wastegate on a 00'
How do I adjust the waste gate on my 00'? I dont see a nut on the rod that I can turn. Do I have to take the whole waste gate off and turn the one end of it. Or is there any easier solution to create more boost.
#3
Registered User
Join Date: Aug 2004
Location: SoCal
Posts: 1,219
Likes: 0
Received 0 Likes
on
0 Posts
There are fittings available that have a restrictor and bleed off hole that will take all of 5 minutes to install.check it out here
http://www.turbodieselregister.com/c...uery=retrieval
Bob
http://www.turbodieselregister.com/c...uery=retrieval
Bob
#5
Administrator
Not likely that you would ever find something like that at a Napa store.
Another thing I just thought of. Even if you put in an elbow, you would not see any benefits without a boost fooler for the ECM. Without the fooler, the ECM will cut back on the fuel to keep the boost pressure down.
Another thing I just thought of. Even if you put in an elbow, you would not see any benefits without a boost fooler for the ECM. Without the fooler, the ECM will cut back on the fuel to keep the boost pressure down.
#6
if you just un-bolt the head it does twist i dont know the difference between automatic and standard trannys just the position. but i would use the adjustable elbow or make your own it cost me $7 at the hardware store and as long as you have a programer or chip you dont need a boost fooler. a boost fooler is just fun for a little extra smoke
Thread
Thread Starter
Forum
Replies
Last Post
hillbillymudrun
Performance and Accessories 2nd gen only
12
01-19-2007 10:38 PM
CTD_Neil
Performance and Accessories 2nd gen only
13
09-22-2005 03:22 PM