3K gsk
#1
Registered User
Thread Starter
Join Date: Mar 2006
Location: Oxnard, Ca.
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
3K gsk
When I get back to the states I am putting in a new p-pump so I was wondering if it would be easier to install the gsk before I put the pump in or should I just wait until I get the pump on the truck?
#6
Banned
Join Date: Apr 2005
Location: Place with no quail:(
Posts: 3,337
Likes: 0
Received 0 Likes
on
0 Posts
It won't make as big of a difference on a 215 pump, but is still quite noticable.
FWIW if I had it to do over, I would get a 4k, I have been told they fuel harder at low RPM.
FWIW if I had it to do over, I would get a 4k, I have been told they fuel harder at low RPM.
#7
Registered User
IMO if your not out trying to fuel hard past 3k I would not recommend the 4k springs. I have not been happy with the idle characteristics of the 4k springs. Mine flutter badly when cold and I just cant tune it out. PDR says its normal but I didnt have it before I put the little springs in.
Trending Topics
#8
Registered User
Join Date: Dec 2003
Location: Garrard county, Kentucky
Posts: 3,077
Likes: 0
Received 0 Likes
on
0 Posts
I wouldnt go back to a 3k. I have harder pull all the way through the RPM's with the 4k over the 3k, and my idle and low rpm characteristics are the same as it was with the 3k. I have the little 160 pump though.
Eric
Eric
#10
Registered User
Join Date: Dec 2003
Location: Garrard county, Kentucky
Posts: 3,077
Likes: 0
Received 0 Likes
on
0 Posts
Well, I ordered the 3k from TST, and then not long ago I ordered the small springs to upgrade to a 4k from piers, but I would imagine everyone uses the same springs. I think the pump might have a lot to do with it. I know some 215's are really touchy with a 4k, where mine isnt too bad, but it could also be they had them adjusted too tight. I would think it should idle smooth either way.
Eric
Eric
#11
Registered User
Well, I ordered the 3k from TST, and then not long ago I ordered the small springs to upgrade to a 4k from piers, but I would imagine everyone uses the same springs. I think the pump might have a lot to do with it. I know some 215's are really touchy with a 4k, where mine isnt too bad, but it could also be they had them adjusted too tight. I would think it should idle smooth either way.
Eric
Eric
#12
Hey CD I have the same pump andf I'm getting ready to get the small springs did you have to do much tuning? Or was it basicly a drop in? Also did you upgrade your valve springs??
Thread
Thread Starter
Forum
Replies
Last Post
SHARPMACHINE
Performance and Accessories 2nd gen only
7
03-06-2007 08:45 AM
MR HYDROSEED
Performance and Accessories 2nd gen only
6
03-09-2005 10:49 PM
Got Smoke?
Performance and Accessories 2nd gen only
7
10-26-2004 03:57 PM