2004 ram wont start..Engine light on?
#1
Registered User
Thread Starter
Join Date: Nov 2007
Location: Alberta Canada
Posts: 2,028
Likes: 0
Received 0 Likes
on
0 Posts
2004 ram wont start..Engine light on?
I have a 2004.5 ram diesel in my signature. Engine light came on. it went off. i pulled camper light came on again. i get codes P0192 P0483. Lift pump pressure is at 6-9 psi and my fuel filter was changed a month ago. Any ideas? its at *********** now. I priced out CP3 and they said $3200 and Fuel rail pressure sensor they said was $800. Can i get either or cheaper anywhere else? Can i get a better CP3 thats better than stock? They said $3200 was for a rebuilt CP3????? What else to check? I did get it running after a few tries and it ran loud like a old 5.9 cummins. like it was getting hardly no fuel....
#3
Registered User
Thread Starter
Join Date: Nov 2007
Location: Alberta Canada
Posts: 2,028
Likes: 0
Received 0 Likes
on
0 Posts
lol nope not yet. still cant find time to install gauges. but i disconnected my boxes at lake and still nothing. i removed edge, quadzilla LP gauge and rail gauge, disconnected batteries for 4 hours...nothing.just busy with kids and new job no time on weekends to do gauges but i will. But this problem really isnt box related. My cp3 might of been dying the last few months resulting in my HIGH EGT or bad box troubles...right?
#4
Registered User
Perty sure it's the rail pressure sensor. Do a search on here about it. I remembering reading about a couple of weeks ago.
Edited: Here it is.... https://www.dieseltruckresource.com/...ighlight=PO193
And this one.
https://www.dieseltruckresource.com/...ighlight=PO193
Edited: Here it is.... https://www.dieseltruckresource.com/...ighlight=PO193
And this one.
https://www.dieseltruckresource.com/...ighlight=PO193
Trending Topics
#9
Registered User
Join Date: Jul 2005
Location: Belgrade, Montana
Posts: 2,953
Likes: 0
Received 0 Likes
on
0 Posts
Rail pressure sensor is about a buck eighty from Cummins and you can buy a CP3 take off almost new for around $400. The rail sensor is about a 20 minute job if you lolly gag. The CP3 is a little more involved but still easy to do at home.
#10
Registered User
Thread Starter
Join Date: Nov 2007
Location: Alberta Canada
Posts: 2,028
Likes: 0
Received 0 Likes
on
0 Posts
ok ill see . dealer is finding out whats wrong wirth truck. i can put parts on. i have no garage but i can do it in the dust. or on the gravel driveway
Thread
Thread Starter
Forum
Replies
Last Post
Haas96
3rd Gen Engine and Drivetrain -> 2003-2007
6
04-13-2014 02:20 AM
takkunram
24 Valve Engine and Drivetrain
3
04-13-2010 05:24 PM
sallyman1
3rd Gen Engine and Drivetrain -> 2003-2007
2
06-26-2008 11:39 PM
twinzilla
3rd Generation Ram - Non Drivetrain - All Years
14
05-23-2007 03:50 PM