1995 Ram 2500
#1
Registered User
Thread Starter
Join Date: Nov 2006
Location: Vermont
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
1995 Ram 2500
Hi Folks,
I need a little advice on what to look at and for on an original owner 95 Cummins Ram 4x4. 172k miles mostly as daily transportation. 5 speed with 3.55 axles. Original clutch and trans. Original untouched engine. He has replaced balljoints and axle ujoints, steering box, shocks and brakes but has original rotors, starter,water pump and belt. Done the work himself. I am going to look at it tomorrow so any help would be appreciated.
Andrew Leven
I need a little advice on what to look at and for on an original owner 95 Cummins Ram 4x4. 172k miles mostly as daily transportation. 5 speed with 3.55 axles. Original clutch and trans. Original untouched engine. He has replaced balljoints and axle ujoints, steering box, shocks and brakes but has original rotors, starter,water pump and belt. Done the work himself. I am going to look at it tomorrow so any help would be appreciated.
Andrew Leven
#2
Registered User
Join Date: Jun 2006
Location: Perdido Beach, Alabama
Posts: 158
Likes: 0
Received 3 Likes
on
3 Posts
Ask if the KDP has been taken care of. Other than normal things to look at rust on frame and body, ANY leaking seals (engine,trans or rearend), any butchered up wiring or other system.
If the engine has not been turned up then everything should be in good condition.
If the engine has not been turned up then everything should be in good condition.
#4
Registered User
Join Date: Nov 2006
Location: Charleston,SC
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
I think that means Killer Dowl Pin...I haven't done mine yet either-just got my truck. But everyone says this little dowl pin can crack the block if it backed out and fell. It is in the front- I think behind the lower timing cover. Maybe someone that knows will shead some light on it for you and I,HTH,Chuck
#5
Registered User
Join Date: Nov 2005
Location: Land of milk and honey.
Posts: 1,971
Likes: 0
Received 1 Like
on
1 Post
whats he askin for it?
check front cover for leaks or cracks. if you are not familiar with the front end, have a shop look it over (they can get pricey to repair) good bargaining tool. take it for a good ride. the 5 speeds had trouble with 5th.
check front cover for leaks or cracks. if you are not familiar with the front end, have a shop look it over (they can get pricey to repair) good bargaining tool. take it for a good ride. the 5 speeds had trouble with 5th.
#6
Registered User
but if its a 4wd, do expect the usual, trackbar, needs an alignment, and possibly the shocks as well..
Rick
#7
Registered User
Join Date: Oct 2004
Location: St Augustine, Florida
Posts: 755
Likes: 0
Received 0 Likes
on
0 Posts
Here is the explanation of KDP (Killer Dowel Pin)..
https://www.dieseltruckresource.com/...n&onlynewfaq=1
https://www.dieseltruckresource.com/...n&onlynewfaq=1
Trending Topics
#9
Registered User
Join Date: Jun 2005
Location: Kansas
Posts: 397
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
EJ RAM
2nd Gen. Dodge Ram - No Drivetrain
6
05-12-2014 09:55 PM
Will Willard
General Diesel Discussion
2
06-07-2013 05:30 PM