Big T

What is the other green plug of the controller for it has 3 wires coming from it can not find it any were in the directions?

vzdude

IIRC thats where I plugged the Xzill box into it. Took the original Xzill controller off, and plugged the commander in. Do you have any power modules on the truck?

Big T

Smarty on level 1

vzdude

Thats a programmer, not a module. So I'm thinking you don't need it plugged into anything. Until you start stacking with a module that is!! LOL

Big T

Thanks for thew info just wasnt sure if it went to the truck anywere. How doese the commander tell it to defuel the truck?

vzdude

I don't think it can with a programmer, just the adjustable modules. Just have to adjust all the warnings to your liking and use the right foot to defuel!

vzdude

BTW, did you buy the a-pillar mount? How did it fit?

Big T

It looks SWEEEEEET like a glove good color match and tecture is dead on.

Big T

One tip I have if you get one On the edge of the dash were the dash meets the door Lay a piece of duct tape on there. Then take a screw driver and manipulate the pillar mount back over top the screwdriver this way you wont mar up the dash.

shortbed rv

I just did mine so I should know. For some reason I can only guess. I believe the second green plug is for the fuel pressure kit. Now I will go look.

Looks like fuel pressure kit connector (green).

qzilla

The only other green plug I can think of has 6 wires in it and it is for the fuel pressure harness??

There should be a grey cable with 2 green plugs and 1 small black plug.

Then you plug the main harness in and it has your connections for boost, coolant and transmission. A two wire (black and white) connection for the Xzillaraider control. And then POwer and Ground.

The other plug has stuff for FP, RP and RPM plus a small 4 pin connector that has 3 wires in it for the translator and other accessories.