03 track bar
#1
Registered User
Thread Starter
Join Date: Jun 2005
Location: Mpls, MN
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
03 track bar
I installed this a couple weeks ago. i can slide it back and forth on the bolt on the frame end. there looks to be too much room on each side of the bar end, where it connects to the bracket. also it looks like the bushing does not stay in the bar end completely. Did i install this wrong? are there suppose to be wshaers on both sides of the bar end?
Thanks,
Hoss15
Thanks,
Hoss15
#2
Registered User
Join Date: Sep 2004
Location: Las Vegas
Posts: 579
Likes: 0
Received 0 Likes
on
0 Posts
Mine was tight on both ends. I can't see being loose on the axle end as being normal. There were no washers with the kit and I have never heard of anyone needing them. Start by checking the part to make sure it's the right one. After that check it against your old track bar. Measure both and compare. If you get different measurements call the place you got it from and talk to them about it.
Thread
Thread Starter
Forum
Replies
Last Post
CTD2001
Performance and Accessories 2nd gen only
3
08-22-2009 10:03 PM