03/04 Waste gate Mods
#3
TST sell a Boost elbow that lets you restrict your waste-gate and you boost will be up. You can adjust how much max boost you get with a allen wrench.I just did it to mine.
http://www.tstproducts.com/index.asp...PROD&ProdID=33
http://www.tstproducts.com/index.asp...PROD&ProdID=33
#6
DTR 1st Sergeant
I did this mod myself. The outlet end of the elbow is a little longer than the stock elbow and difficult to put on without taking stuff apart. You can remove the stock elbow easy enough reaching from the bottom of the truck. If you drill a hole through the top of the elbow from the treaded side of the elbow as your guide and taking care not to "ream" it out, I think it was a 7/32 drill I used the tap with a 1/4" tap and use a 1/4"x1/2" set screw, you can adjust the airflow from full to nothing or anything in between. Takes no more than 1/2 hour for the whole project. Be sure to use loctite on the set screw when you have it where you want it.
#7
DTR 1st Sergeant
And I forgot to mention--- I already had the tap and drill on hand so the only expense was the set screw at less than a buck. And a few cents worth of loctite that I already had too...
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
nasty01cummims
Performance and Accessories 2nd gen only
2
04-23-2009 07:36 PM
azdodge
3rd Gen High Performance and Accessories (5.9L Only)
22
05-14-2007 05:32 AM
whiteknight
24 Valve Engine and Drivetrain
17
01-08-2003 10:38 PM