nintythree2wd

I bought a new 2wd 1500 in 99.other than the normal trans issues for that year it's been a good truck.I put a fab tech 3" lift on it a while back,which has heavier springs than stock.I also replaced all balljoints with moog grease fitting type ball joints.Then I ran across a 93 d250 with 127000 original miles for a grand,estate sale couldnt pass it up. runs great but it's beaten up bad.how hard would it be to convert my 1500 to a 12 valve?I guess the ? is will the fab tech suspension hold up?Thanks

wannadiesel

Yeah, the suspension will be fine. If it sits too low you can use diesel springs.

Getting the dash to work will be a challenge.

Check your state laws before you start swapping, quite a few states won't let you install an engine older than the chassis.